This Vicenzo flueless fireplace is eco-friendly and uses bioethanol, which is an an environmentally friendly, non-polluting, odourless, carbon neutral fluid. It allows you to sit around this fireplace without the usual inconvenience of smoke and clothes smelling of smoke. 100% of heat energy produced by a this bioethanol fireplace remains in the room. It is extremely useful for new build homes and apartments without a flue.
Features and Specification:
- Product Code: Biofp4
- Fuel Type: Bio eithanol
- Fuel Capacity: 1300ml
- Glass Thickness: 6mm
- Fireplace Size(WxDxH): 26cm x 50cm x 60cm
- Glass Size: 60cm x 50cm
- Packing Size: 65cm x 19cm x 57cm
- Safety glass with bevelled edge (2 panels)
- Adjustable flame snuffer to snuff the fire out
- Stainless steel double walled burner
First remove the stainless steel burner from the slot in the base of the fire. Place the Vicenzo Fireplace on a table covered with a blanket or carpet. Identify the fixings and plastic washers, and put them within reach. Assembly is more comfortable if you are sitting down.
Now place the fireplace so it is standing vertically on a small end.
Carefully place both glass panels flat on the table where they will not fall or be damaged. Do not drop the glass panels of they will break. Remove the protective wrappings from the glass panels.
Put a plastic washer on the round fixing bolt. When ready carefully pick up a glass panel and still holding base of the fire vertically and the glass panel at right angles align the holes and insert the first fixing in one of the four threaded holes on the side of the fireplace. Make the plastic washer on the outside of the glass panel.
Still holding the base and the glass panel align the hole in the panel with the hole in the second hole and insert the second fixing. Make sure there is a plastic washer on the outside of the glass panel. Repeat for all four fixings.
Repeat the procedure for the second glass panel.
Do not over tighten the fixings, which should be only finger tight - do not tighten with pliers or similar.
Replace the stainless steel burner back in the slot.
Assembly is now complete, lift the fireplace by holding the base. Do not lift the fire place by the glass panels.
Burning time is dependent on the location of the fireplace (outside burns faster than inside), and other factors such as the air temperature. We tested this burner indoors at room temperature and found that 500ml of bioethanol burned for aproximately 1 1/4 hours.
Always observe all the user instructions when using bio-ethanol fuelled fireplaces. Please see the Usage and Maintenance details for full information.
We Also Recommend